xtal
Junior Member
Posts: 61
|
Post by xtal on Mar 30, 2018 17:23:40 GMT -5
|
|
xtal
Junior Member
Posts: 61
|
Post by xtal on Mar 30, 2018 17:24:59 GMT -5
See if this posts
|
|
xtal
Junior Member
Posts: 61
|
Post by xtal on Apr 7, 2018 8:37:05 GMT -5
This is same as G-Code sender thread.....
There is a Q_A.txt [Questions and Answers] file to help with usage. This a a G-Code Sender that sends supported G-Code to an Arduino Uno Engine with a CNC Shield approx $30 or less The Arduino Shield is running GRBL 1.1f code from git-hub. The Sender was written to run on 1.1f I've tried to have a button for all basic commands.....This has been quite a learning exercise. LB 4.5.1 was used so a couple of new instructions was used... Its still a work in progress, I have done small 7 PC boards with my homebuilt CNC machine, and 2 of the PCB's were made for my cnc...
|
|
xtal
Junior Member
Posts: 61
|
Post by xtal on Apr 25, 2018 11:35:58 GMT -5
|
|