Found some Syntax errors converting file to Liberty Basic 5.
Sept 13, 2022 14:33:58 GMT -5
Carl Gundel likes this
Post by greenhornetno1 on Sept 13, 2022 14:33:58 GMT -5
The following lines worked fine for Liberty Basic 4.5 but in 5.0 I get
Syntax error -, if RouteW(10) = 4 goto [RouteW10Done]
The Help file states: Since the expression after THEN is a branch label, this command may also be written using the GOTO statement instead of the THEN statement.
if fuel < 5 goto [soundAlarm]
Any time the statement after THEN is a branch label, you may use GOTO instead of THEN.
Syntax error -, #main, "drawbmp Lamp-B 1304 519" ' Clear all buttons
Also the Find Ctrl-F and Find and Replace Ctrl-R does not allow Pasting, and on 4.5 you could Copy a piece of text and then do a ctrl-F and the search panel would come up with this work already selected.
Also the Find and replace after selecting the Replace it goes back to the start of the search instead of the next Find.
Just a side note the Arduino IDE Find and replace pop up panel is really good. You can dock it outside your work area and look and replace while working.
Syntax error -, if RouteW(10) = 4 goto [RouteW10Done]
The Help file states: Since the expression after THEN is a branch label, this command may also be written using the GOTO statement instead of the THEN statement.
if fuel < 5 goto [soundAlarm]
Any time the statement after THEN is a branch label, you may use GOTO instead of THEN.
Syntax error -, #main, "drawbmp Lamp-B 1304 519" ' Clear all buttons
Also the Find Ctrl-F and Find and Replace Ctrl-R does not allow Pasting, and on 4.5 you could Copy a piece of text and then do a ctrl-F and the search panel would come up with this work already selected.
Also the Find and replace after selecting the Replace it goes back to the start of the search instead of the next Find.
Just a side note the Arduino IDE Find and replace pop up panel is really good. You can dock it outside your work area and look and replace while working.
